% IMPORTANT: The following is UTF-8 encoded.  This means that in the presence
% of non-ASCII characters, it will not work with BibTeX 0.99 or older.
% Instead, you should use an up-to-date BibTeX implementation like “bibtex8” or
% “biber”.

@ARTICLE{Menzler:153211,
      author       = {Menzler, Norbert H. and Malzbender, Jürgen and
                      Schoderböck, P. and Kauert, Ralf and Buchkremer, Hans
                      Peter},
      title        = {{S}equential {T}ape {C}asting of {A}node-{S}upported
                      {S}olid {O}xide {F}uel {C}ells},
      journal      = {Fuel cells},
      volume       = {14},
      number       = {1},
      issn         = {1615-6854},
      address      = {Weinheim},
      publisher    = {Wiley-VCH},
      reportid     = {FZJ-2014-02858},
      pages        = {96-106},
      year         = {2014},
      abstract     = {A novel route was developed to fabricate anode-supported
                      solid oxide fuel cells with a high throughput and low
                      manufacturing costs. In contrast to classical manufacturing
                      routes, this novel route starts with the tape casting of the
                      thin electrolyte followed by the tape casting of the anode
                      and anode support. All three layers were cast green-on-green
                      and finally sintered to yield a gas-tight electrolyte. By
                      carefully selecting the raw materials for all three layers,
                      it is possible to manufacture near-net-shape half-cells. The
                      half-cells were characterized with respect to thickness,
                      microstructure, bending behavior, electrolyte gas leakage,
                      shrinkage, electrolyte residual stresses, and mechanical
                      strength. Finally, the cathode was screen-printed and fired,
                      and the full cell characteristics were obtained in
                      single-cell and stack tests. Additionally, a scale-up to
                      cell sizes of 200 × 200 mm2 was verified. Electrolyte
                      and anode thickness were around 20 μm, and the support
                      was cast to 300–500 μm. The helium leak rates were
                      better than the necessary internal threshold, and the
                      characteristic bending strength obtained was in the range of
                      150–200 MPa. The single-cell tests revealed current
                      densities of 1.0 A cm–2 at 700 mV and 800 °C
                      (H2/air). A first stack test proved their stackability and
                      operational functionality},
      cin          = {IEK-1 / IEK-2},
      ddc          = {620},
      cid          = {I:(DE-Juel1)IEK-1-20101013 / I:(DE-Juel1)IEK-2-20101013},
      pnm          = {123 - Fuel Cells (POF2-123) / SOFC - Solid Oxide Fuel Cell
                      (SOFC-20140602)},
      pid          = {G:(DE-HGF)POF2-123 / G:(DE-Juel1)SOFC-20140602},
      typ          = {PUB:(DE-HGF)16},
      UT           = {WOS:000331904000012},
      doi          = {10.1002/fuce.201300153},
      url          = {https://juser.fz-juelich.de/record/153211},
}