% IMPORTANT: The following is UTF-8 encoded.  This means that in the presence
% of non-ASCII characters, it will not work with BibTeX 0.99 or older.
% Instead, you should use an up-to-date BibTeX implementation like “bibtex8” or
% “biber”.

@ARTICLE{Rajasekaran:15694,
      author       = {Rajasekaran, B. and Mauer, G. and Vaßen, R. and Röttger,
                      A. and Weber, S. and Theisen, W.},
      title        = {{T}hick cold work tool steel coating by {HVOF} spraying for
                      wear resistance application},
      journal      = {Surface and coatings technology},
      volume       = {205},
      issn         = {0257-8972},
      address      = {Amsterdam [u.a.]},
      publisher    = {Elsevier Science},
      reportid     = {PreJuSER-15694},
      pages        = {2449 - 2454},
      year         = {2010},
      note         = {The authors gratefully acknowledge the financial support
                      from the German Research Foundation (DFG-Project-No:
                      TH531/6-1; VA163/4-1).},
      abstract     = {This paper deals with the processing of thick cold work
                      tool steel coating using high velocity oxy-fuel (HVOF)
                      spraying process. A full factorial experimental design was
                      established to identify the influencing process parameters
                      on the formation of dense coating with low oxidation.
                      Microstructural analysis of the coating was carried out
                      using optical, SEM and XRD techniques. Cold work tool steel
                      coatings with a thickness up to 2 mm were developed on bond
                      coated low carbon steel substrates for wear resistance
                      evaluation. A pin on disc test was performed to examine the
                      wear resistance of thick cold work tool steel coatings on
                      different types and sizes of abrasive papers. The wear
                      results were compared with the wear resistance of a standard
                      high speed steel pin. The abrasive wear resistance of cold
                      work tool steel coated pins was found to be superior against
                      soft and fine abrasive papers than the standard high speed
                      steel. Besides, the performance of the coated pins against
                      hard and coarser abrasive papers was found to be similar to
                      standard high speed steel. The study showed the potential of
                      HVOF spraying on the development of thick cold work tool
                      steel coatings for wear resistance applications. (C) 2010
                      Elsevier B.V. All rights reserved.},
      keywords     = {J (WoSType)},
      cin          = {IEK-1},
      ddc          = {620},
      cid          = {I:(DE-Juel1)IEK-1-20101013},
      pnm          = {Rationelle Energieumwandlung},
      pid          = {G:(DE-Juel1)FUEK402},
      shelfmark    = {Materials Science, Coatings $\&$ Films / Physics, Applied},
      typ          = {PUB:(DE-HGF)16},
      UT           = {WOS:000286343100088},
      doi          = {10.1016/j.surfcoat.2010.09.041},
      url          = {https://juser.fz-juelich.de/record/15694},
}