% IMPORTANT: The following is UTF-8 encoded. This means that in the presence
% of non-ASCII characters, it will not work with BibTeX 0.99 or older.
% Instead, you should use an up-to-date BibTeX implementation like “bibtex8” or
% “biber”.
@ARTICLE{Patriarca:15978,
author = {Patriarca, C. and Lambot, S. and Mahmoudzadeh, M.R. and
Minet, J. and Slob, E.},
title = {{R}econstruction of sub-wavelength fractures and physical
properties of masonry media using full-waveform inversion of
proximal penetrating radar},
journal = {Journal of applied geophysics},
volume = {74},
issn = {0926-9851},
address = {Amsterdam [u.a.]},
publisher = {Elsevier Science},
reportid = {PreJuSER-15978},
pages = {26 - 37},
year = {2011},
note = {The research leading to these results has received funding
from the European Community's Seventh Framework Programme
[FP7/2007-2013] under grant agreement no. 213651. The
research was further supported by the DIGISOIL project,
financed by the EC under the 7th Framework Programme for
Research and Technology Development, Area "Environment",
Activity 6.3 "Environmental Technologies" and FNRS
(Belgium). We also thank the editor and two unknown
reviewers for their helpful comments.},
abstract = {High-frequency, ultra-wideband penetrating radar has the
potential to be used as a non-invasive inspection technique
for buildings, providing high-resolution images of
structures and possible fractures affecting constructions.
To test this possibility, numerical and laboratory
experiments have been conducted using a proximal,
stepped-frequency continuous-wave radar system operating in
zero-offset mode, spanning the 3-8 GHz frequency range. The
reconstruction of the material electrical properties is
achieved by resorting to full-waveform inverse modeling.
Numerical experiments showed that for typical electric
permittivity and electrical conductivity values of concrete
and plaster, it is possible to retrieve the physical
properties of the material and to detect fractures less than
1 mm thick Laboratory experiments were conducted on
non-reinforced concrete and plaster test slabs in different
configurations. The results showed the good potential of
this method: (1) to provide a thorough fracture response
model in buildings or artworks and (2) to non-invasively
characterize the samples in terms of their electromagnetic
properties. (C) 2011 Elsevier B.V. All rights reserved.},
keywords = {J (WoSType)},
cin = {IBG-3},
ddc = {620},
cid = {I:(DE-Juel1)IBG-3-20101118},
pnm = {Terrestrische Umwelt / STONECORE - Stone conservation for
the refurbishment of buildings (213651)},
pid = {G:(DE-Juel1)FUEK407 / G:(EU-Grant)213651},
shelfmark = {Geosciences, Multidisciplinary / Mining $\&$ Mineral
Processing},
typ = {PUB:(DE-HGF)16},
UT = {WOS:000291291300004},
doi = {10.1016/j.jappgeo.2011.03.001},
url = {https://juser.fz-juelich.de/record/15978},
}