000032188 001__ 32188
000032188 005__ 20240711092257.0
000032188 0247_ $$2Handle$$a2128/308
000032188 0247_ $$2URI$$a308
000032188 037__ $$aPreJuSER-32188
000032188 0881_ $$aJuel-4067
000032188 088__ $$2JUEL$$aJuel-4067
000032188 1001_ $$0P:(DE-Juel1)VDB26456$$aKlabbers-Heimann, Jürgen Johannes$$b0$$eCorresponding author$$uFZJ
000032188 245__ $$aAnwendungsgrenzen von modernen Nickelbasis-Superlegierungen in effusionsgekühlten Bauteilen zukünftiger Gasturbinen
000032188 260__ $$aJülich$$bForschungszentrum Jülich GmbH Zentralbibliothek, Verlag$$c2003
000032188 300__ $$a135 p.
000032188 3367_ $$0PUB:(DE-HGF)11$$2PUB:(DE-HGF)$$aDissertation / PhD Thesis
000032188 3367_ $$0PUB:(DE-HGF)3$$2PUB:(DE-HGF)$$aBook
000032188 3367_ $$02$$2EndNote$$aThesis
000032188 3367_ $$2DRIVER$$adoctoralThesis
000032188 3367_ $$2BibTeX$$aPHDTHESIS
000032188 3367_ $$2DataCite$$aOutput Types/Dissertation
000032188 3367_ $$2ORCID$$aDISSERTATION
000032188 4900_ $$0PERI:(DE-600)2414853-2$$89443$$aBerichte des Forschungszentrums Jülich$$v4067$$x0944-2952
000032188 502__ $$aAachen, Techn. Hochsch., Diss., 2003$$bDr. (FH)$$cTechn. Hochsch. Aachen$$d2003
000032188 500__ $$aRecord converted from VDB: 12.11.2012
000032188 520__ $$aThe deformation and damage behaviour of two nickel-base superalloys, CMSX-4 and SX CM186LC, have been investigated. Hot-tensile, tensile creep and low-cycle-fatigue tests have been performed on single crystal and directionally solidified variants at temperatures up to 1000°C to compare their tensile-, creep- and fatigue behaviour. The strength and fatigue properties of both materials were significantly influenced by their different microstructures. Comparing the single crystal materials, CMSX-4 exhibited in strain rate controlled tensile tests (1000°C) higher strength properties than SX CM186LC. The heterogeneity of the microstructure development of SX CM186LC favoured crack initiation and explains the worse fatigue behaviour. Crack growth followed mainly in the interdendritic regions. In the temperature range of 750 to 1000°C, the creep resistance of SX CM186LC was lower than that of CMSX-4. In isothermal fatigue tests the advantage of the single crystal variants compared to the directionally solidified variants was demonstrated. Bond coating of MCrAlY on single crystal specimens seemed to have a positive effect on life time compared to directionally solidified variants. The difference in the materials behaviour could be clearly demonstrated by a comparison between the homogeneous microstructure of CMSX-4 and the heterogeneous microstructure of SX CM186LC. Based on some oxidation test results mentioned in the open literature together with isothermal oxidation tests carried out in a temperature range of 550 to 1000°C, CMSX-4 exhibited good oxidation resistance, which meant that the cooling channels (drillings) did not close up due to oxide scale formation. Principally this work concentrated on the set-up and testing method for in-situ investigations in the scanning electron microscope (SEM). In-situ investigations in the SEM were carried out to obtain a description of micro-crack (smaller than 100 mm) initiation and growth, starting from laser drilled cooling channels. The development of the SEM investigation showed that crack initiation started mainly at the base of the drilling, crack propagation appeared to be perpendicular to the main load stress direction and crack growth ran along the cooling channels located perpendicular to the main load. In-situ testing in the SEM represents a new testing method. The results which described the material behaviour could be used in the evaluation of the operational limits of effusion cooled components in modern industrial gas turbines.
000032188 536__ $$0G:(DE-Juel1)FUEK248$$2G:(DE-HGF)$$aWerkstoffsysteme für Kraftwerke$$cE03$$x0
000032188 655_7 $$aHochschulschrift$$xDissertation (FH)
000032188 8564_ $$uhttps://juser.fz-juelich.de/record/32188/files/Juel_4067_Klabbers.pdf$$yOpenAccess
000032188 909CO $$ooai:juser.fz-juelich.de:32188$$pdnbdelivery$$pVDB$$pdriver$$popen_access$$popenaire
000032188 915__ $$0StatID:(DE-HGF)0510$$2StatID$$aOpenAccess
000032188 9141_ $$y2003
000032188 9131_ $$0G:(DE-Juel1)FUEK248$$bEnergie$$kE03$$lRationelle Energieumwandlung$$vWerkstoffsysteme für Kraftwerke$$x0
000032188 9201_ $$0I:(DE-Juel1)VDB2$$d31.12.2006$$gIWV$$kIWV-2$$lWerkstoffstruktur und Eigenschaften$$x0
000032188 970__ $$aVDB:(DE-Juel1)33985
000032188 9801_ $$aFullTexts
000032188 980__ $$aVDB
000032188 980__ $$aJUWEL
000032188 980__ $$aConvertedRecord
000032188 980__ $$aphd
000032188 980__ $$aI:(DE-Juel1)IEK-2-20101013
000032188 980__ $$aUNRESTRICTED
000032188 980__ $$aFullTexts
000032188 981__ $$aI:(DE-Juel1)IMD-1-20101013
000032188 981__ $$aI:(DE-Juel1)IEK-2-20101013