% IMPORTANT: The following is UTF-8 encoded. This means that in the presence
% of non-ASCII characters, it will not work with BibTeX 0.99 or older.
% Instead, you should use an up-to-date BibTeX implementation like “bibtex8” or
% “biber”.
@ARTICLE{Meyburg:42877,
author = {Meyburg, S. and Goryll, M. and Moers, J. and Ingebrandt, S.
and Böcker-Meffert, S. and Lüth, H. and Offenhäusser, A.},
title = {{N}-{C}hannel {F}ield {E}ffect {T}ransistors with
{F}loating {G}ates for {E}xtracellular {R}ecordings},
journal = {Biosensors and bioelectronics},
volume = {21},
issn = {0956-5663},
address = {Amsterdam [u.a.]},
publisher = {Elsevier Science},
reportid = {PreJuSER-42877},
pages = {1037 - 1044},
year = {2006},
note = {Record converted from VDB: 12.11.2012},
abstract = {A field-effect transistor (FET) for recording extracellular
signals from electrogenic cells is presented. The so-called
floating gate architecture combines a complementary metal
oxide semiconductor (CMOS)-type n-channel transistor with an
independent sensing area. This concept allows the transistor
and sensing area to be optimised separately. The devices are
robust and can be reused several times. The noise level of
the devices was smaller than of comparable non-metallised
gate FETs. In addition to the usual drift of FET devices, we
observed a long-term drift that has to be controlled for
future long-term measurements. The device performance for
extracellular signal recording was tested using embryonic
rat cardiac myocytes cultured on fibronectin-coated chips.
The extracellular cell signals were recorded before and
after the addition of the cardioactive isoproterenol. The
signal shapes of the measured action potentials were
comparable to the non-metallised gate FETs previously used
in similar experiments. The fabrication of the devices
involved the process steps of standard CMOS that were
necessary to create n-channel transistors. The
implementation of a complete CMOS process would facilitate
the integration of the logical circuits necessary for signal
pre-processing on a chip, which is a prerequisite for a
greater number of sensor spots in future layouts.},
keywords = {Action Potentials: physiology / Amplifiers, Electronic /
Animals / Biosensing Techniques: instrumentation / Cells,
Cultured / Equipment Design / Equipment Failure Analysis /
Membrane Potentials: physiology / Microelectrodes /
Myocytes, Cardiac: physiology / Rats / Rats, Wistar /
Reproducibility of Results / Sensitivity and Specificity /
Transistors, Electronic / J (WoSType)},
cin = {ISG-2 / CNI / JARA-FIT},
ddc = {570},
cid = {I:(DE-Juel1)VDB42 / I:(DE-Juel1)VDB381 /
$I:(DE-82)080009_20140620$},
pnm = {Grundlagen für zukünftige Informationstechnologien},
pid = {G:(DE-Juel1)FUEK412},
shelfmark = {Biophysics / Biotechnology $\&$ Applied Microbiology /
Chemistry, Analytical / Electrochemistry / Nanoscience $\&$
Nanotechnology},
typ = {PUB:(DE-HGF)16},
pubmed = {pmid:16029948},
UT = {WOS:000234644400007},
doi = {10.1016/j.bios.2005.03.010},
url = {https://juser.fz-juelich.de/record/42877},
}