% IMPORTANT: The following is UTF-8 encoded. This means that in the presence
% of non-ASCII characters, it will not work with BibTeX 0.99 or older.
% Instead, you should use an up-to-date BibTeX implementation like “bibtex8” or
% “biber”.
@PHDTHESIS{Li:62607,
author = {Li, Haifeng},
title = {{S}ynthesis of {CMR} manganites and ordering phenomena in
complex transition metal oxides},
volume = {4},
school = {RWTH Aachen},
type = {Dr. (Univ.)},
address = {Jülich},
publisher = {Forschungszentrum Jülich GmbH Zentralbibliothek, Verlag},
reportid = {PreJuSER-62607},
isbn = {978-3-89336-527-2},
series = {Schriften des Forschungszentrums Jülich.
Schlüsseltechnologien / Key Technologies},
pages = {III, 175 S.},
year = {2008},
note = {Record converted from VDB: 12.11.2012; RWTH Aachen, Diss.,
2008},
abstract = {This dissertation covers: the instrumentation development;
the optimization synthesis of polycrystalline materials; the
single crystal growth of perovskite manganites; the
determination of crystal and magnetic structures from x-ray
and neutron powder diffraction data of polycrystalline and
powdered single-crystalline CMR La$_{1-x}$Sr$_{x}$MnO$_{3}$
manganites as well as its application in quantitatively
correlating structural and magnetic properties; the
application of resonant soft x-ray scattering in the
investigation of complex ordering phenomena in
La$_{7/8}$Sr$_{1/8}$MnO$_{3}$ and
La$_{1}$Sr$_{2}$Mn$_{2}$O$_{7}$ at the transition metal
L$_{II, III}$-edges and the rare earth M$_{IV, V}$-edges.
Two new devices have been developed: one is the rotating
specimen holder for laboratory x-ray powder diffraction,
which not only can effectively minimize the problem of
preferred orientation but also produces a
‘zero-background’ contribution to the collected data;
another is the miniature goniometer for resonant soft x-ray
scattering, which makes it feasible to adjust samples along
$\chi$ (±2.5°) and $\Psi$ (360°) and dramatically
improves the efficiency of soft x-ray scattering chambers
and can be utilized to unravel the electronic ordering
phenomena by resonant soft x-ray scattering. The materials
synthesis is the first and critical step for any research in
condensed matter physics. One good route has been acquired
for preparing high-quality polycrystalline
La$_{7/8}$Sr$_{1/8}$MnO$_{3}$ samples, i.e. two times
calcining and two times sintering, through exploring various
preparation parameters. This synthesis route can be also
used to prepare high-quality La$_{1}$Sr$_{2}$Mn$_{2}$O$_{7}$
and La$_{0.83}$Ca$_{0.17}$MnO$_{3}$. Thus it is a universal
one for the present testing. The route for optimizing the
synthesis of polycrystalline manganites has been
established. One method for preparing straight and very
uniformly densified feed rods with a homogenous composition
distribution has been acquired, which makes growing large
high-quality single crystals possible. Three nominal
La$_{1-x}$Sr$_{x}$MnO$_{3}$ (x = 1/8) polycrystals prepared
under different conditions air, Ar and O$_{2}$ at 1 atm show
a huge contrast in the Curie temperature T$_{c}$. A combined
Rietveld refinement of the room-temperature x-ray and
neutron powder diffraction data has been performed for these
three samples. This study not only can determine the
relative content of the various elements (especially the
oxygen) with higher precision as compared to one probe
alone, but also makes it possible to correlate the drastic
change in Tc with the detailed structural parameters. In
addition, the individual effect of the number of nearest
magnetic neighbors on the structural and magnetic properties
has been investigated in detail using a set of
La$_{7/8}$Sr$_{1/8}$Mn$_{y}$O$_{3}$ samples with initial y =
0.97, 1.00 and 1.03. Moreover, a systematic neutron powder
diffraction study of the Ar annealed and air sintered
La$_{7/8}$Sr$_{1/8}$Mn$_{1- \gamma}$O$_{3+ \delta}$ samples
between 10 and 900 K has been performed, where the
structural and magnetic phases and their respective
transitions for two samples are completely different. For
the air sintered sample, a structural transition from
rhombohedral to orthorhombic upon cooling from 180 to 65 K
has been observed for the first time. From the refined
parameters the cooperative Jahn- Teller distortion parameter
$\Delta$, the tolerance factor $\textit{t}$ based on the
equilibrium La(Sr)-O and Mn-O bond lengths, and the
one-electron bandwidth $\textit{W}$ of the e$_{g}$-band have
been determined.},
cin = {IFF-4 / JARA-FIT / IFF-5 / Jülich Centre for Neutron
Science JCNS (JCNS) ; JCNS},
cid = {I:(DE-Juel1)VDB784 / $I:(DE-82)080009_20140620$ /
I:(DE-Juel1)VDB785 / I:(DE-Juel1)JCNS-20121112},
pnm = {Kondensierte Materie / Großgeräte für die Forschung mit
Photonen, Neutronen und Ionen (PNI)},
pid = {G:(DE-Juel1)FUEK414 / G:(DE-Juel1)FUEK415},
typ = {PUB:(DE-HGF)11 / PUB:(DE-HGF)3},
url = {https://juser.fz-juelich.de/record/62607},
}