001     818231
005     20240711092249.0
024 7 _ |a 10.1016/j.surfcoat.2016.08.074
|2 doi
024 7 _ |a 0257-8972
|2 ISSN
024 7 _ |a 1879-3347
|2 ISSN
024 7 _ |a WOS:000390622200051
|2 WOS
037 _ _ |a FZJ-2016-04714
082 _ _ |a 620
100 1 _ |a Dashjav, E.
|0 P:(DE-Juel1)156509
|b 0
|e Corresponding author
245 _ _ |a Atomic layer deposition and high-resolution electron microscopy characterization of nickel nanoparticles for catalyst applications
260 _ _ |a Amsterdam [u.a.]
|c 2016
|b Elsevier Science
336 7 _ |a article
|2 DRIVER
336 7 _ |a Output Types/Journal article
|2 DataCite
336 7 _ |a Journal Article
|b journal
|m journal
|0 PUB:(DE-HGF)16
|s 1475668895_14266
|2 PUB:(DE-HGF)
336 7 _ |a ARTICLE
|2 BibTeX
336 7 _ |a JOURNAL_ARTICLE
|2 ORCID
336 7 _ |a Journal Article
|0 0
|2 EndNote
520 _ _ |a Ni nanoparticles (diameter < 10 nm) are deposited on Si and ceramic substrates of porous lanthanum-substituted strontium titanate/yttrium-stabilized zirconia (LST/YSZ) composites by a two-step process. First, NiO films are produced by atomic layer deposition at 200 °C using bis(methylcyclopentadienyl)nickel(II) (Ni(MeCp)2) and H2O as precursors. In the second step, the NiO films are reduced in H2 atmosphere at 400–800 °C. The size of the resulting Ni nanoparticles is controlled by the temperature. The largest particles with a diameter of about 7 nm are obtained at 800 °C. NiO film and Ni nanoparticles deposited on Si substrates are characterized by high-resolution electron microscopy. It was found that the Ni(MeCp)2 precursor reacts with the substrate, leading to the formation of NiSi2 precipitates beneath the surface of the Si wafer and amorphization of the surrounding area, resulting in a 10 nm thick top layer of the Si wafer. After reductive annealing, NiSi2 precipitates are preserved but Si recrystallizes and the amorphous NiO film transforms into crystalline Ni nanoparticles well distributed on the wafer surface. Process parameters were optimized for Si substrates and transfer of the process to ceramic LST/YSZ substrates is possible in principle. However, a much higher number of ALD cycles (1200 compared to 100 for Si) are necessary to obtain Ni nanoparticles of similar size and the number density of particles is lower than observed for Si substrates.
536 _ _ |a 134 - Electrolysis and Hydrogen (POF3-134)
|0 G:(DE-HGF)POF3-134
|c POF3-134
|f POF III
|x 0
588 _ _ |a Dataset connected to CrossRef
700 1 _ |a Lipińska-Chwałek, M.
|0 P:(DE-HGF)0
|b 1
700 1 _ |a Grüner, D.
|0 P:(DE-Juel1)145209
|b 2
700 1 _ |a Mauer, G.
|0 P:(DE-Juel1)129633
|b 3
700 1 _ |a Luysberg, M.
|0 P:(DE-Juel1)130811
|b 4
700 1 _ |a Tietz, F.
|0 P:(DE-Juel1)129667
|b 5
773 _ _ |a 10.1016/j.surfcoat.2016.08.074
|g p. S0257897216308398
|0 PERI:(DE-600)1502240-7
|p 428-435
|t Surface and coatings technology
|v 307
|y 2016
|x 0257-8972
856 4 _ |u https://juser.fz-juelich.de/record/818231/files/1-s2.0-S0257897216308398-main.pdf
|y Restricted
856 4 _ |x icon
|u https://juser.fz-juelich.de/record/818231/files/1-s2.0-S0257897216308398-main.gif?subformat=icon
|y Restricted
856 4 _ |x icon-1440
|u https://juser.fz-juelich.de/record/818231/files/1-s2.0-S0257897216308398-main.jpg?subformat=icon-1440
|y Restricted
856 4 _ |x icon-180
|u https://juser.fz-juelich.de/record/818231/files/1-s2.0-S0257897216308398-main.jpg?subformat=icon-180
|y Restricted
856 4 _ |x icon-640
|u https://juser.fz-juelich.de/record/818231/files/1-s2.0-S0257897216308398-main.jpg?subformat=icon-640
|y Restricted
856 4 _ |x pdfa
|u https://juser.fz-juelich.de/record/818231/files/1-s2.0-S0257897216308398-main.pdf?subformat=pdfa
|y Restricted
909 C O |o oai:juser.fz-juelich.de:818231
|p VDB
|p OpenAPC
|p openCost
910 1 _ |a Forschungszentrum Jülich
|0 I:(DE-588b)5008462-8
|k FZJ
|b 0
|6 P:(DE-Juel1)156509
910 1 _ |a Forschungszentrum Jülich
|0 I:(DE-588b)5008462-8
|k FZJ
|b 2
|6 P:(DE-Juel1)145209
910 1 _ |a Forschungszentrum Jülich
|0 I:(DE-588b)5008462-8
|k FZJ
|b 3
|6 P:(DE-Juel1)129633
910 1 _ |a Forschungszentrum Jülich
|0 I:(DE-588b)5008462-8
|k FZJ
|b 4
|6 P:(DE-Juel1)130811
910 1 _ |a Forschungszentrum Jülich
|0 I:(DE-588b)5008462-8
|k FZJ
|b 5
|6 P:(DE-Juel1)129667
913 1 _ |a DE-HGF
|l Speicher und vernetzte Infrastrukturen
|1 G:(DE-HGF)POF3-130
|0 G:(DE-HGF)POF3-134
|2 G:(DE-HGF)POF3-100
|v Electrolysis and Hydrogen
|x 0
|4 G:(DE-HGF)POF
|3 G:(DE-HGF)POF3
|b Energie
914 1 _ |y 2016
915 _ _ |a DBCoverage
|0 StatID:(DE-HGF)0200
|2 StatID
|b SCOPUS
915 _ _ |a DBCoverage
|0 StatID:(DE-HGF)1160
|2 StatID
|b Current Contents - Engineering, Computing and Technology
915 _ _ |a DBCoverage
|0 StatID:(DE-HGF)0600
|2 StatID
|b Ebsco Academic Search
915 _ _ |a No Authors Fulltext
|0 StatID:(DE-HGF)0550
|2 StatID
915 _ _ |a JCR
|0 StatID:(DE-HGF)0100
|2 StatID
|b SURF COAT TECH : 2015
915 _ _ |a DBCoverage
|0 StatID:(DE-HGF)0150
|2 StatID
|b Web of Science Core Collection
915 _ _ |a WoS
|0 StatID:(DE-HGF)0110
|2 StatID
|b Science Citation Index
915 _ _ |a WoS
|0 StatID:(DE-HGF)0111
|2 StatID
|b Science Citation Index Expanded
915 _ _ |a IF < 5
|0 StatID:(DE-HGF)9900
|2 StatID
915 _ _ |a Peer Review
|0 StatID:(DE-HGF)0030
|2 StatID
|b ASC
915 _ _ |a DBCoverage
|0 StatID:(DE-HGF)0300
|2 StatID
|b Medline
915 _ _ |a Nationallizenz
|0 StatID:(DE-HGF)0420
|2 StatID
915 _ _ |a DBCoverage
|0 StatID:(DE-HGF)0199
|2 StatID
|b Thomson Reuters Master Journal List
920 1 _ |0 I:(DE-Juel1)IEK-1-20101013
|k IEK-1
|l Werkstoffsynthese und Herstellungsverfahren
|x 0
920 1 _ |0 I:(DE-Juel1)IEK-2-20101013
|k IEK-2
|l Werkstoffstruktur und -eigenschaften
|x 1
920 1 _ |0 I:(DE-Juel1)PGI-5-20110106
|k PGI-5
|l Mikrostrukturforschung
|x 2
980 _ _ |a journal
980 _ _ |a VDB
980 _ _ |a UNRESTRICTED
980 _ _ |a I:(DE-Juel1)IEK-1-20101013
980 _ _ |a I:(DE-Juel1)IEK-2-20101013
980 _ _ |a I:(DE-Juel1)PGI-5-20110106
980 _ _ |a APC
981 _ _ |a I:(DE-Juel1)IMD-1-20101013
981 _ _ |a I:(DE-Juel1)IMD-2-20101013
981 _ _ |a I:(DE-Juel1)ER-C-1-20170209
981 _ _ |a I:(DE-Juel1)IEK-2-20101013
981 _ _ |a I:(DE-Juel1)PGI-5-20110106


LibraryCollectionCLSMajorCLSMinorLanguageAuthor
Marc 21