TY  - JOUR
AU  - Thiem, P. G.
AU  - Chornyi, A.
AU  - Smirnov, I. V.
AU  - Krüger, M.
TI  - Comparison of Microstructure and Adhesion Strength of Plasma, Flame and High Velocity Oxy-Fuel Sprayed CoatingsFfrom an Iron Aluminide Powder
JO  - Surface and coatings technology
VL  - 324
SN  - 0257-8972
CY  - Amsterdam [u.a.]
PB  - Elsevier Science
M1  - FZJ-2017-05979
SP  - 498 - 508
PY  - 2017
AB  - In this study an iron aluminide powder with the feedstock powder composition of Fe-28Al-5Cr and a particle size of 45 μm to 75 μm was thermally sprayed onto AlSi10Mg and AlSi12CuNiMg substrates by flame spray (FS), atmospheric plasma spray (APS) and high velocity oxy-fuel spray (HVOF) processes. The combination of the utilized materials is due to lightweight design and is, therefore, different from most of the previous studies, which dealt with the application of iron aluminide coatings onto steels. Coatings were analyzed in terms of microstructural investigations using SEM coupled with EDX measurements in the as sprayed condition and after a heat treatment of 100 h at 500 °C in argon atmosphere. Phase analysis was performed by XRD measurements in the as sprayed and heat treated condition. The FS and APS coatings contained different amounts of a bcc solid solution α(Fe, Al, Cr), FeO, Fe3O4, FeAl2O4 and γ-Al2O3. It was found that the FeO rearranged to bcc Fe and Fe3O4 during this heat treatment. The HVOF coating retained 90% of feedstock powder material and a low fraction of oxide and Al-depleted phases. The microhardness was determined to be 277 HV0.4 (FS), 394 HV0.4 (APS) and 479 HV0.4 (HVOF) which was associated to the different constituting phases. Adhesion strength was measured using the tensile adhesion test (TAT) and the achieved adhesion was 13.8 MPa (APS), 30.3 MPa (FS) and exceeded 58 MPa (HVOF).
LB  - PUB:(DE-HGF)16
UR  - <Go to ISI:>//WOS:000406988200057
DO  - DOI:10.1016/j.surfcoat.2017.06.016
UR  - https://juser.fz-juelich.de/record/836957
ER  -