TY  - JOUR
AU  - Marcano, D.
AU  - Mauer, G.
AU  - Vaßen, R.
AU  - Weber, A.
TI  - Manufacturing of high performance solid oxide fuel cells (SOFCs) with atmospheric plasma spraying (APS) and plasma spray-physical vapor deposition (PS-PVD)
JO  - Surface and coatings technology
VL  - 318
SN  - 0257-8972
CY  - Amsterdam [u.a.]
PB  - Elsevier Science
M1  - FZJ-2018-00184
SP  - 170 - 177
PY  - 2017
AB  - In the present work, a metal supported SOFC half-cell was fabricated by means of plasma spray. As support, a Fe-Cr alloy with a porous structure was used. The anode and electrolyte were applied using atmospheric plasma spray (APS) and plasma spray-physical vapor deposition (PS-PVD), respectively. A standard Ni/YSZ (coat mix) powder was used for the anode and the cathode layer consisted of a screen-printed La0.58Sr0.4Co0.2Fe0.8O3 − δ (LSCF) non-sintered paste. The development of a thin, dense, gas-tight 8YSZ electrolyte was the key issue of this work. Analysis of microstructure, phases, and gas-tightness were carried out for various processing conditions. Different parameters were varied, such as: powder feed rate and carrier gas flow rate, robot speed, spraying distance and plasma gas composition. A partially reduced anode coating with 9% porosity and a gas-tight 26 μm electrolyte layer were obtained. Such an assembly was air-tight and delivered a cell with an acceptable open circuit voltage (OCV) and an excellent performance of 1 A/cm2 at 800 °C and 0.7 V.
LB  - PUB:(DE-HGF)16
UR  - <Go to ISI:>//WOS:000402356100020
DO  - DOI:10.1016/j.surfcoat.2016.10.088
UR  - https://juser.fz-juelich.de/record/841887
ER  -