% IMPORTANT: The following is UTF-8 encoded.  This means that in the presence
% of non-ASCII characters, it will not work with BibTeX 0.99 or older.
% Instead, you should use an up-to-date BibTeX implementation like “bibtex8” or
% “biber”.

@ARTICLE{Marcano:841887,
      author       = {Marcano, D. and Mauer, G. and Vaßen, R. and Weber, A.},
      title        = {{M}anufacturing of high performance solid oxide fuel cells
                      ({SOFC}s) with atmospheric plasma spraying ({APS}) and
                      plasma spray-physical vapor deposition ({PS}-{PVD})},
      journal      = {Surface and coatings technology},
      volume       = {318},
      issn         = {0257-8972},
      address      = {Amsterdam [u.a.]},
      publisher    = {Elsevier Science},
      reportid     = {FZJ-2018-00184},
      pages        = {170 - 177},
      year         = {2017},
      abstract     = {In the present work, a metal supported SOFC half-cell was
                      fabricated by means of plasma spray. As support, a Fe-Cr
                      alloy with a porous structure was used. The anode and
                      electrolyte were applied using atmospheric plasma spray
                      (APS) and plasma spray-physical vapor deposition (PS-PVD),
                      respectively. A standard Ni/YSZ (coat mix) powder was used
                      for the anode and the cathode layer consisted of a
                      screen-printed La0.58Sr0.4Co0.2Fe0.8O3 − δ (LSCF)
                      non-sintered paste. The development of a thin, dense,
                      gas-tight 8YSZ electrolyte was the key issue of this work.
                      Analysis of microstructure, phases, and gas-tightness were
                      carried out for various processing conditions. Different
                      parameters were varied, such as: powder feed rate and
                      carrier gas flow rate, robot speed, spraying distance and
                      plasma gas composition. A partially reduced anode coating
                      with $9\%$ porosity and a gas-tight 26 μm electrolyte layer
                      were obtained. Such an assembly was air-tight and delivered
                      a cell with an acceptable open circuit voltage (OCV) and an
                      excellent performance of 1 A/cm2 at 800 °C and 0.7 V.},
      cin          = {IEK-1 / IEK-9},
      ddc          = {620},
      cid          = {I:(DE-Juel1)IEK-1-20101013 / I:(DE-Juel1)IEK-9-20110218},
      pnm          = {113 - Methods and Concepts for Material Development
                      (POF3-113)},
      pid          = {G:(DE-HGF)POF3-113},
      typ          = {PUB:(DE-HGF)16},
      UT           = {WOS:000402356100020},
      doi          = {10.1016/j.surfcoat.2016.10.088},
      url          = {https://juser.fz-juelich.de/record/841887},
}