% IMPORTANT: The following is UTF-8 encoded. This means that in the presence
% of non-ASCII characters, it will not work with BibTeX 0.99 or older.
% Instead, you should use an up-to-date BibTeX implementation like “bibtex8” or
% “biber”.
@ARTICLE{MahboobKanafi:860464,
author = {Mahboob Kanafi, Mona and Tuononen, Ari Juhani and Dorogin,
Leonid and Persson, Bo},
title = {{R}ubber friction on 3{D}-printed randomly rough surfaces
at low and high sliding speeds},
journal = {Wear},
volume = {376-377},
issn = {0043-1648},
address = {Amsterdam [u.a.]},
publisher = {Elsevier Science},
reportid = {FZJ-2019-01218},
pages = {1200 - 1206},
year = {2017},
abstract = {Rubber friction depends on the surface roughness of the
counter surface, e.g. a road surface. We have measured the
friction for two rubber compounds sliding on randomly rough
surfaces produced by 3D-printing. The surfaces had different
macro-roughness and the friction experiments were performed
over six decades in speeds, from 10−6 m s−1 to 1 m
s−1, on both dry and lubricated substrates. The
viscoelastic modulus master curves of the rubber compounds,
and their large-strain effective modulus were obtained from
dynamic mechanical analysis (DMA). The measured friction
coefficients were compared to the calculations of rubber
friction using Persson's contact mechanics theory. The role
of the macro-level roughness is discussed.},
cin = {IAS-1 / PGI-1 / JARA-FIT / JARA-HPC},
ddc = {670},
cid = {I:(DE-Juel1)IAS-1-20090406 / I:(DE-Juel1)PGI-1-20110106 /
$I:(DE-82)080009_20140620$ / $I:(DE-82)080012_20140620$},
pnm = {141 - Controlling Electron Charge-Based Phenomena
(POF3-141)},
pid = {G:(DE-HGF)POF3-141},
typ = {PUB:(DE-HGF)16},
UT = {WOS:000403902000033},
doi = {10.1016/j.wear.2017.01.092},
url = {https://juser.fz-juelich.de/record/860464},
}