% IMPORTANT: The following is UTF-8 encoded.  This means that in the presence
% of non-ASCII characters, it will not work with BibTeX 0.99 or older.
% Instead, you should use an up-to-date BibTeX implementation like “bibtex8” or
% “biber”.

@ARTICLE{Dash:877881,
      author       = {Dash, Apurv and Malzbender, Jürgen and Vaßen, Robert and
                      Guillon, Olivier and Gonzalez‐Julian, Jesus},
      title        = {{S}hort {S}i{C} fiber/{T}i 3 {S}i{C} 2 {MAX} phase
                      composites: {F}abrication and creep evaluation},
      journal      = {Journal of the American Ceramic Society},
      volume       = {103},
      number       = {12},
      issn         = {1551-2916},
      address      = {Westerville, Ohio},
      publisher    = {Soc.},
      reportid     = {FZJ-2020-02488},
      pages        = {7072-7081},
      year         = {2020},
      abstract     = {The compressive creep of silicon carbide fiber reinforced
                      Ti3SiC2 MAX phase with both fine and coarse microstructure
                      was investigated in the temperature range of 1000‐1300°C.
                      Comparison of only steady‐state creep was done to
                      understand the response of fabricated composite materials
                      toward creep deformation. It was demonstrated that the
                      fibers are more effective in reducing the creep rates for
                      the coarse microstructure by an increase in activation
                      energy compared to the variant with a finer microstructure,
                      being partly a result of the enhanced creep rates for the
                      microstructure with larger grain size. Grain boundary
                      sliding along with fiber fracture appears to be the main
                      creep mechanism for most of the tested temperature range.
                      However, there are indications for a changed creep mechanism
                      for the fine microstructure for the lowest testing
                      temperature. Local pores are formed to accommodate
                      differences in strain related to creeping matrix and
                      predominantly elastically deformed fibers during creep.
                      Microstructural analysis was done on the material before and
                      after creep to understand the deformation mechanics.},
      cin          = {IEK-1},
      ddc          = {660},
      cid          = {I:(DE-Juel1)IEK-1-20101013},
      pnm          = {899 - ohne Topic (POF3-899)},
      pid          = {G:(DE-HGF)POF3-899},
      typ          = {PUB:(DE-HGF)16},
      UT           = {WOS:000546911600001},
      doi          = {10.1111/jace.17337},
      url          = {https://juser.fz-juelich.de/record/877881},
}