000877986 001__ 877986
000877986 005__ 20210130005320.0
000877986 020__ $$a978-3-89336-689-7
000877986 0247_ $$2Handle$$a2128/25325
000877986 037__ $$aFZJ-2020-02560
000877986 041__ $$aEnglish
000877986 1001_ $$0P:(DE-HGF)0$$aFielitz, Daniel$$b0$$eCorresponding author
000877986 245__ $$a2D cross-hole MMR – Survey design and sensitivity analysis for cross-hole applications of the magnetometric resistivity method$$f - 2010
000877986 260__ $$aJülich$$bForschungszentrum Jülich GmbH Zentralbibliothek, Verlag$$c2010
000877986 300__ $$aXVI, 123 S.
000877986 3367_ $$2DataCite$$aOutput Types/Dissertation
000877986 3367_ $$0PUB:(DE-HGF)3$$2PUB:(DE-HGF)$$aBook$$mbook
000877986 3367_ $$2ORCID$$aDISSERTATION
000877986 3367_ $$2BibTeX$$aPHDTHESIS
000877986 3367_ $$02$$2EndNote$$aThesis
000877986 3367_ $$0PUB:(DE-HGF)11$$2PUB:(DE-HGF)$$aDissertation / PhD Thesis$$bphd$$mphd$$s1594893273_3303
000877986 3367_ $$2DRIVER$$adoctoralThesis
000877986 4900_ $$aSchriften des Forschungszentrums Jülich Reihe Energie & Umwelt / Energy & Environment$$v95
000877986 502__ $$aDissertation, Universität Köln, 2010$$bDissertation$$cUniversität Köln$$d2010
000877986 520__ $$aThe magnetometric resistivity (MMR) method measures low-level (typically < 1nT) magnetic fields associated with a low-frequency (1 - 20 Hz) electric current impressed into the ground to determine the subsurface resistivity structure. As a step towards the implementation of MMR for cross-hole imaging, in this Ph.D. thesis several aspects of survey design for near-surface applications are discussed. In numerical, laboratory and field studies the potential of MMR for advanced structural characterization and process monitoring at the field scale is assessed. The 2D cross-hole setup considers borehole measurements of the magnetic field as response to borehole current injection; in this case the magnetic field has only one non-zero component (perpendicular to the imaging plane – B$_{y}$). Optimal survey parameters are inferred from numerical studies regarding signal strength, source-generated noise level and resolving power. Modeling of MMR responses over 2D conductivity structures was performed using a newly developed 2.5D FE program MMRMod. It could be proven that current injection via vertical dipoles provides superior signal-to-noise ratio compared to other transmitter configurations. Analyzing resolving power in terms of sensitivity distribution reveals that dipole configurations reflect confined subsurface volumes, advantageous for tomographic surveys and that transmitter-receiver combinations exceeding an offset equal to the borehole separation do not contribute significantly to the overall crosshole resolution. With the assistance of laboratory testing two concepts for solving two major difficulties inherent in cross-hole MMR field surveying are derived: the correction for the arbitrary borehole sensor orientation and the correction for parasitic correlated noise fields induced by the measurement system itself. The (latter) measurement method with phase switching is thereby first-time successfully applied to the processing of MMR data. In addition, the proposed data processing procedure includes modern lock-in-technique and has proven to be an appropriate tool for an effective information extraction from the measured magnetic fields. Finally, cross-hole MMR data were collected during a water infiltration experiment at the Gorgonzola test site. Acquisition and processing are accomplished according to the developed tomographic measurement approach involving multiple-offset transmitter-receiver arrangements and repeated measurements with time (time-lapse mode). Data, obtained during initially conducted background measurement, are qualitatively validated based on two different conductivity models, one of which is obtained from the inversion of independently collected ERT data. Importantly, the comparison of field data with predicted model curves suggests better resolvability of contrasts by MMR than by ERT. Moreover, the analysis of time-lapse measurements reveals a clear spatiotemporal dependence of the anomalous MMRresponse (MMR response with respect to background value) based upon the water saturation. 
000877986 536__ $$0G:(DE-HGF)POF3-899$$a899 - ohne Topic (POF3-899)$$cPOF3-899$$fPOF III$$x0
000877986 8564_ $$uhttps://juser.fz-juelich.de/record/877986/files/Energie%26Umwelt_095.pdf$$yOpenAccess
000877986 8564_ $$uhttps://juser.fz-juelich.de/record/877986/files/Energie%26Umwelt_095.pdf?subformat=pdfa$$xpdfa$$yOpenAccess
000877986 909CO $$ooai:juser.fz-juelich.de:877986$$pdnbdelivery$$pdriver$$pVDB$$popen_access$$popenaire
000877986 9101_ $$0I:(DE-588b)5008462-8$$6P:(DE-HGF)0$$aForschungszentrum Jülich$$b0$$kFZJ
000877986 9131_ $$0G:(DE-HGF)POF3-899$$1G:(DE-HGF)POF3-890$$2G:(DE-HGF)POF3-800$$3G:(DE-HGF)POF3$$4G:(DE-HGF)POF$$aDE-HGF$$bProgrammungebundene Forschung$$lohne Programm$$vohne Topic$$x0
000877986 915__ $$0StatID:(DE-HGF)0510$$2StatID$$aOpenAccess
000877986 920__ $$lyes
000877986 9201_ $$0I:(DE-Juel1)PRE2000-20140101$$kPRE-2000 ; Retrocat$$lPublikationen vor 2000$$x0
000877986 9201_ $$0I:(DE-Juel1)IBG-3-20101118$$kIBG-3$$lAgrosphäre$$x1
000877986 980__ $$aphd
000877986 980__ $$aVDB
000877986 980__ $$aUNRESTRICTED
000877986 980__ $$abook
000877986 980__ $$aI:(DE-Juel1)PRE2000-20140101
000877986 980__ $$aI:(DE-Juel1)IBG-3-20101118
000877986 9801_ $$aFullTexts