TY  - JOUR
AU  - Zhao, Yue
AU  - Yoshimura, Kimio
AU  - Mahmoud, Ahmed Mohamed Ahmed
AU  - Yu, Hwan-Chul
AU  - Okushima, Shun
AU  - Hiroki, Akihiro
AU  - Kishiyama, Yoshihiro
AU  - Shishitani, Hideyuki
AU  - Yamaguchi, Susumu
AU  - Tanaka, Hirohisa
AU  - Noda, Yohei
AU  - Koizumi, Satoshi
AU  - Radulescu, Aurel
AU  - Maekawa, Yasunari
TI  - A long side chain imidazolium-based graft-type anion-exchange membrane: novel electrolyte and alkaline-durable properties and structural elucidation using SANS contrast variation
JO  - Soft matter
VL  - 16
IS  - 35
SN  - 1744-6848
CY  - London
PB  - Royal Soc. of Chemistry
M1  - FZJ-2020-03146
SP  - 8128-8143
PY  - 2020
AB  - Newly designed styrylimidazolium-based grafted anion-exchange membranes (StIm-AEMs), in which imidazolium ionic groups are attached to styrene at the far side from the graft chains, were prepared by radiation-induced graft polymerization of p-(2-imidazoliumyl) styrene onto poly(ethylene-co-tetrafluoloethylene) (ETFE) films, followed by N-alkylation and ion-exchange reactions. StIm-AEM having an ion exchange capacity (IEC) of 0.54 mmol g−1 with a grafting degree (GD) of ∼18%, possesses practical conductivity (>50 mS cm−1) even with a very low water uptake (∼10%) and high stability over 600 h in a 1 M KOH solution at 80 °C. There exists a critical IEC (IECc) in the range of 0.7–0.8 mmol g−1 over which the membrane showed high water uptake, which resulted in pronounced susceptibility to hydrolysis. Using small-angle neutron scattering technique with a contrast variation method, we found the hydrophilic phase in StIm-AEMs with IECs lower and higher than IECc shows “reverse-micelles” with water domains dispersed in the polymer matrix and “micelles” with graft polymer aggregates dispersed in the water matrix, respectively. The further analysis of micelle structures using the hard-sphere liquid model and Porod limit analysis reveals that the interfacial structures of ionic groups are essential for the electrochemical properties and durability of StIm-AEMs. In addition, StIm-AEM with an IEC of 0.95 mmol g−1 and the maximum power density of 80 mW cm−2 in the hydrazine hydrate fuel cell test, exhibited long-term durability under constant current (8.0 mA) up to 455 h, which, thus far, is the best durability at 80 °C for platinum-free alkaline-type liquid fuel cells.
LB  - PUB:(DE-HGF)16
C6  - pmid:32735002
UR  - <Go to ISI:>//WOS:000569505000019
DO  - DOI:10.1039/D0SM00947D
UR  - https://juser.fz-juelich.de/record/884247
ER  -