Home > Publications database > Synthese von Cr$_{2}$AlC MAX-Phasen Kompositen und Bestimmung ihrer oxidativen Eigenschaften > print

001     903943
005     20240711085623.0
020 _ _ |a 978-3-95806-598-7
024 7 _ |2 Handle
|a 2128/29857
037 _ _ |a FZJ-2021-05551
041 _ _ |a German
100 1 _ |0 P:(DE-Juel1)171463
|a Go, Teresa
|b 0
|e Corresponding author
|g female
|u fzj
245 _ _ |a Synthese von Cr$_{2}$AlC MAX-Phasen Kompositen und Bestimmung ihrer oxidativen Eigenschaften
|f - 2021-10-22
260 _ _ |a Jülich
|b Forschungszentrum Jülich GmbH Zentralbibliothek Verlag
|c 2021
300 _ _ |a ii, 119 S.
336 7 _ |2 DataCite
|a Output Types/Dissertation
336 7 _ |0 PUB:(DE-HGF)3
|2 PUB:(DE-HGF)
|a Book
|m book
336 7 _ |2 ORCID
|a DISSERTATION
336 7 _ |2 BibTeX
|a PHDTHESIS
336 7 _ |0 2
|2 EndNote
|a Thesis
336 7 _ |0 PUB:(DE-HGF)11
|2 PUB:(DE-HGF)
|a Dissertation / PhD Thesis
|b phd
|m phd
|s 1641369406_10771
336 7 _ |2 DRIVER
|a doctoralThesis
490 0 _ |a Schriften des Forschungszentrums Jülich. Reihe Energie & Umwelt / Energy & Environment
|v 558
502 _ _ |a RWTH Aachen, Diss., 2021
|b Dissertation
|c RWTH Aachen University
|d 2021
520 _ _ |a Three different ceramic matrix composites (CMCs) were produced using Cr$_{2}$AlC as a matrix, and carbon, SiC, and Al$_{2}$O$_{3}$ short fibers as a secondary phase. Cr$_{2}$AlC powders were synthesized by solid-state reaction, followed by mixing with the fibers, and full densification using a field-assisted sintering technique (FAST/SPS). Carbon fibers react strongly with Cr$_{2}$AlC, meaning that these composites are not suitable for use, while the reaction of SiC fibers is less strong. The composites containing alumina fibers do not exhibit any reaction. Oxidation tests of the monolithic Cr$_{2}$AlC and the composites were performed by thermogravimetric analysis. Of all the chosen CMCs, 10 wt.% SiC fibers resulted in the lowest mass gain. The parabolic and cubic rates of oxidation were determined to find the best fitting calculation. The overall oxidation response is parabolic. The alumina layer formed at 1000 °C is well attached and the oxidation response is good. However, at 1200 °C, this layer detached for monolithic material and 10 wt.% Al$_{2}$O$_{3}$ fibers. In long-term oxidation tests at 1200 °C for 4 weeks, a strong reaction of the CMCs in contrast to the monolithic material is observed. The oxidation response of the alumina fiber CMC is good under realistic conditions using a burner rig for cyclic oxidation, as defects or degradation are barely visible, and the alumina layer is well attached. The mechanical reinforcement effect of the fibers was implemented by measuring the compressive streng that room temperature and 900 °C. This reinforcement is clearly evident here. CMCs with Al$_{2}$O$_{3}$-fibers with stand higher compressive stresses than monolithic material. The highest compressive stresses are measured in CMCs with SiC fibers, whereby the reason for this increase can also lie in the secondary phases that arise during sintering.
536 _ _ |0 G:(DE-HGF)POF4-899
|a 899 - ohne Topic (POF4-899)
|c POF4-899
|f POF IV
|x 0
856 4 _ |u https://juser.fz-juelich.de/record/903943/files/Energie_Umwelt_558.pdf
|y OpenAccess
909 C O |o oai:juser.fz-juelich.de:903943
|p openaire
|p open_access
|p VDB
|p driver
|p dnbdelivery
910 1 _ |0 I:(DE-588b)5008462-8
|6 P:(DE-Juel1)171463
|a Forschungszentrum Jülich
|b 0
|k FZJ
913 1 _ |0 G:(DE-HGF)POF4-899
|1 G:(DE-HGF)POF4-890
|2 G:(DE-HGF)POF4-800
|3 G:(DE-HGF)POF4
|4 G:(DE-HGF)POF
|a DE-HGF
|b Programmungebundene Forschung
|l ohne Programm
|v ohne Topic
|x 0
914 1 _ |y 2021
915 _ _ |0 StatID:(DE-HGF)0510
|2 StatID
|a OpenAccess
915 _ _ |0 LIC:(DE-HGF)CCBY4
|2 HGFVOC
|a Creative Commons Attribution CC BY 4.0
920 _ _ |l yes
920 1 _ |0 I:(DE-Juel1)IEK-1-20101013
|k IEK-1
|l Werkstoffsynthese und Herstellungsverfahren
|x 0
980 1 _ |a FullTexts
980 _ _ |a phd
980 _ _ |a VDB
980 _ _ |a UNRESTRICTED
980 _ _ |a book
980 _ _ |a I:(DE-Juel1)IEK-1-20101013
981 _ _ |a I:(DE-Juel1)IMD-2-20101013

LibraryCollectionCLSMajorCLSMinorLanguageAuthor
Marc 21