000904071 001__ 904071
000904071 005__ 20250701125909.0
000904071 0247_ $$2doi$$a10.1016/j.fusengdes.2021.112645
000904071 0247_ $$2ISSN$$a0920-3796
000904071 0247_ $$2ISSN$$a1873-7196
000904071 0247_ $$2WOS$$aWOS:000670076200009
000904071 037__ $$aFZJ-2021-05641
000904071 082__ $$a530
000904071 1001_ $$00000-0002-6231-6241$$aRieth, M.$$b0
000904071 245__ $$aTechnological aspects in blanket design: Effects of micro-alloying and thermo-mechanical treatments of EUROFER97 type steels after neutron irradiation
000904071 260__ $$aNew York, NY [u.a.]$$bElsevier$$c2021
000904071 3367_ $$2DRIVER$$aarticle
000904071 3367_ $$2DataCite$$aOutput Types/Journal article
000904071 3367_ $$0PUB:(DE-HGF)16$$2PUB:(DE-HGF)$$aJournal Article$$bjournal$$mjournal$$s1642780807_21910
000904071 3367_ $$2BibTeX$$aARTICLE
000904071 3367_ $$2ORCID$$aJOURNAL_ARTICLE
000904071 3367_ $$00$$2EndNote$$aJournal Article
000904071 500__ $$akein Zugriff auf Postprint
000904071 520__ $$aPresently available data on neutron irradiation damage raise doubts on the feasibility of using EUROFER97 steel for a water-cooled starter blanket in a DEMO reactor, since the ductile-to-brittle transition temperature (DBTT) increases significantly for irradiation temperatures below 350°C. The additional DBTT shift caused by H and He transmutation can only be estimated based on very few results with isotopically tailored EUROFER97 steel. Conservative calculations show that the DBTT of EUROFER97 steel could exceed the operating temperature in water-cooled starter blankets within a relatively short time period. This paper presents results from a EUROfusion funded irradiation campaign that was performed in the High Flux Isotope Reactor at Oak Ridge National Laboratory. The paper compares ten newly developed reduced activation ferritic-martensitic (RAFM) steels irradiated to a nominal dose of 2.5 dpa at 300°C. The post-irradiation experiments using Small Specimen Test Technology included hardness, tensile, and fracture mechanics tests combined with fractography and microstructure analysis are presented. Results show that micro-alloying EUROFER97-type steels influenced the mechanical properties but a dominating impact on irradiation damage resistance could not be identified. In contrast, specific thermo-mechanical treatments lead to better DBTT behavior. Discussion about irradiation response to heat treatment conditions is also given. Despite requiring data also at high dpa values, the results indicate that with these modified materials an increased lifetime and potentially also an increased operating temperature window can be achieved compared to EUROFER97.
000904071 536__ $$0G:(DE-HGF)POF4-134$$a134 - Plasma-Wand-Wechselwirkung (POF4-134)$$cPOF4-134$$fPOF IV$$x0
000904071 588__ $$aDataset connected to CrossRef, Journals: juser.fz-juelich.de
000904071 7001_ $$00000-0002-8094-281X$$aSimondon, E.$$b1
000904071 7001_ $$0P:(DE-Juel1)129778$$aPintsuk, G.$$b2$$eCorresponding author
000904071 7001_ $$0P:(DE-HGF)0$$aAiello, G.$$b3
000904071 7001_ $$0P:(DE-HGF)0$$aHenry, J.$$b4
000904071 7001_ $$0P:(DE-HGF)0$$aTerentyev, D.$$b5
000904071 7001_ $$00000-0002-7862-285X$$aPuype, A.$$b6
000904071 7001_ $$00000-0001-5668-290X$$aCristalli, C.$$b7
000904071 7001_ $$0P:(DE-HGF)0$$aPilloni, L.$$b8
000904071 7001_ $$0P:(DE-HGF)0$$aTassa, O.$$b9
000904071 7001_ $$0P:(DE-HGF)0$$aKlimenkov, M.$$b10
000904071 7001_ $$aSchneider, H.-C.$$b11
000904071 7001_ $$0P:(DE-HGF)0$$aFernandez, P.$$b12
000904071 7001_ $$0P:(DE-Juel1)133143$$aGräning, T.$$b13
000904071 7001_ $$0P:(DE-Juel1)159191$$aChen, X.$$b14
000904071 7001_ $$0P:(DE-Juel1)128659$$aBhattacharya, A.$$b15
000904071 7001_ $$0P:(DE-HGF)0$$aReed, J.$$b16
000904071 7001_ $$0P:(DE-HGF)0$$aGeringer, J. W.$$b17
000904071 7001_ $$0P:(DE-HGF)0$$aSokolov, M.$$b18
000904071 7001_ $$0P:(DE-HGF)0$$aKatoh, Y.$$b19
000904071 7001_ $$aSnead, L.$$b20
000904071 773__ $$0PERI:(DE-600)1492280-0$$a10.1016/j.fusengdes.2021.112645$$gVol. 168, p. 112645 -$$p112645 -$$tFusion engineering and design$$v168$$x0920-3796$$y2021
000904071 8564_ $$uhttps://juser.fz-juelich.de/record/904071/files/et%20design-1.pdf$$yRestricted
000904071 909CO $$ooai:juser.fz-juelich.de:904071$$pVDB
000904071 9101_ $$0I:(DE-588b)5008462-8$$6P:(DE-Juel1)129778$$aForschungszentrum Jülich$$b2$$kFZJ
000904071 9101_ $$0I:(DE-588b)5008462-8$$6P:(DE-Juel1)133143$$aForschungszentrum Jülich$$b13$$kFZJ
000904071 9131_ $$0G:(DE-HGF)POF4-134$$1G:(DE-HGF)POF4-130$$2G:(DE-HGF)POF4-100$$3G:(DE-HGF)POF4$$4G:(DE-HGF)POF$$aDE-HGF$$bForschungsbereich Energie$$lFusion$$vPlasma-Wand-Wechselwirkung$$x0
000904071 9141_ $$y2021
000904071 915__ $$0StatID:(DE-HGF)0420$$2StatID$$aNationallizenz$$d2021-01-27$$wger
000904071 915__ $$0StatID:(DE-HGF)0199$$2StatID$$aDBCoverage$$bClarivate Analytics Master Journal List$$d2021-01-27
000904071 915__ $$0StatID:(DE-HGF)0160$$2StatID$$aDBCoverage$$bEssential Science Indicators$$d2021-01-27
000904071 915__ $$0StatID:(DE-HGF)1160$$2StatID$$aDBCoverage$$bCurrent Contents - Engineering, Computing and Technology$$d2021-01-27
000904071 915__ $$0StatID:(DE-HGF)0113$$2StatID$$aWoS$$bScience Citation Index Expanded$$d2021-01-27
000904071 915__ $$0StatID:(DE-HGF)0150$$2StatID$$aDBCoverage$$bWeb of Science Core Collection$$d2021-01-27
000904071 915__ $$0StatID:(DE-HGF)0100$$2StatID$$aJCR$$bFUSION ENG DES : 2019$$d2021-01-27
000904071 915__ $$0StatID:(DE-HGF)0200$$2StatID$$aDBCoverage$$bSCOPUS$$d2021-01-27
000904071 915__ $$0StatID:(DE-HGF)0600$$2StatID$$aDBCoverage$$bEbsco Academic Search$$d2021-01-27
000904071 915__ $$0StatID:(DE-HGF)0030$$2StatID$$aPeer Review$$bASC$$d2021-01-27
000904071 915__ $$0StatID:(DE-HGF)9900$$2StatID$$aIF < 5$$d2021-01-27
000904071 9201_ $$0I:(DE-Juel1)IEK-4-20101013$$kIEK-4$$lPlasmaphysik$$x0
000904071 9201_ $$0I:(DE-Juel1)ZEA-1-20090406$$kZEA-1$$lZentralinstitut für Technologie$$x1
000904071 980__ $$ajournal
000904071 980__ $$aVDB
000904071 980__ $$aI:(DE-Juel1)IEK-4-20101013
000904071 980__ $$aI:(DE-Juel1)ZEA-1-20090406
000904071 980__ $$aUNRESTRICTED
000904071 981__ $$aI:(DE-Juel1)ITE-20250108
000904071 981__ $$aI:(DE-Juel1)IFN-1-20101013