% IMPORTANT: The following is UTF-8 encoded.  This means that in the presence
% of non-ASCII characters, it will not work with BibTeX 0.99 or older.
% Instead, you should use an up-to-date BibTeX implementation like “bibtex8” or
% “biber”.

@ARTICLE{Leonard:907171,
      author       = {Leonard, Kwati and Ivanova, Mariya E. and Weber, André and
                      Deibert, Wendelin and Meulenberg, Wilhelm A. and Ishihara,
                      Tatsumi and Matsumoto, Hiroshige},
      title        = {{A}node supported planar 5 × 5 cm2
                      {S}r{Z}r0.5{C}e0.4{Y}0.1{O}2.95 based solid oxide protonic
                      fuel cells via sequential tape-casting},
      journal      = {Solid state ionics},
      volume       = {379},
      issn         = {0167-2738},
      address      = {Amsterdam [u.a.]},
      publisher    = {Elsevier Science},
      reportid     = {FZJ-2022-01876},
      pages        = {115918 -},
      year         = {2022},
      abstract     = {Solid oxide protonic fuel cells are one of the most
                      efficient means of directly converting stored chemical
                      energy to usable electrical energy. Acceptor-doped Ba(Zr,
                      Ce)O3 perovskite-type oxides are the preferred electrolyte
                      choice as they provide higher conductivity due to lower
                      activation energy. While substantial progress has been made
                      on small-sized protonic laboratory-scale cells, a
                      considerable challenge has been upscaling robust planar-type
                      devices. This paper employs a cost-effective inverse tape
                      casting route and screen printing to fabricate flat planar
                      anode-supported protonic fuel cells consisting of
                      NiO-SrZr0.5Ce0.4Y0.1O3-δ substrate, SrZr0.5Ce0.4Y0.1O3-δ
                      electrolyte, and BaCo0.4Fe0.4Zr0.1Y 0.1O3-δ as the cathode.
                      The processing parameters were analyzed and adjusted to
                      obtain defect-free single cells of dimension up to 100 mm ×
                      100 mm × 0.5 mm with diminished warping. In addition, the
                      smooth tri-layered green tapes yielded suitably dense and
                      gas-tight electrolyte layers after co-sintering at 1300
                      °C/5 h. Finally, the electrochemical performance of the 50
                      × 50 mm2 SrZr0.5Ce0.4Y0.1O2.95 based cells was evaluated,
                      and their impedance spectra were deconvoluted to identify
                      all performance-related polarization processes via the
                      distribution of relaxation time.},
      cin          = {IEK-1},
      ddc          = {530},
      cid          = {I:(DE-Juel1)IEK-1-20101013},
      pnm          = {1232 - Power-based Fuels and Chemicals (POF4-123)},
      pid          = {G:(DE-HGF)POF4-1232},
      typ          = {PUB:(DE-HGF)16},
      UT           = {WOS:000793570000008},
      doi          = {10.1016/j.ssi.2022.115918},
      url          = {https://juser.fz-juelich.de/record/907171},
}