% IMPORTANT: The following is UTF-8 encoded.  This means that in the presence
% of non-ASCII characters, it will not work with BibTeX 0.99 or older.
% Instead, you should use an up-to-date BibTeX implementation like “bibtex8” or
% “biber”.

@ARTICLE{Menzler:9390,
      author       = {Menzler, N. H. and Haanappel, V. A. C.},
      title        = {{I}nfluence of anode thickness on the power output of solid
                      oxide fuel cells with ({L}a,{S}r)({C}o,{F}e)-type cathode},
      journal      = {Journal of power sources},
      volume       = {195},
      issn         = {0378-7753},
      address      = {New York, NY [u.a.]},
      publisher    = {Elsevier},
      reportid     = {PreJuSER-9390},
      pages        = {5340 - 5343},
      year         = {2010},
      note         = {Record converted from VDB: 12.11.2012},
      abstract     = {The influence of the thickness of the anode (functional
                      layer) on the power output of anode-supported solid oxide
                      fuel cells with a lanthanum-strontium-cobalt-ferrite cathode
                      was investigated. The anode was applied by vacuum slip
                      casting and the thickness varied between 1 and 22 mu m. All
                      other material and microstructural parameters were kept
                      constant. Single cells with dimensions of 50 mm x 50 mm and
                      with an active cathode area of 40 mm x 40 mm were
                      manufactured and tested in an alumina housing with air as
                      oxidant and hydrogen with $3\%$ water vapour as the fuel
                      gas.Results have shown that SOFCs with anodes between 1 and
                      13 mu m have slightly better performance than those with
                      thicker anodes (similar to 1.7A cm(-2) versus 1.5 A cm(-2)
                      at 800 degrees C and 0.7 V). The current densities were
                      discussed with respect to cell area specific resistance,
                      helium leak rate of the half-cell, and microstructure. (C)
                      2010 Elsevier B.V. All rights reserved.},
      keywords     = {J (WoSType)},
      cin          = {IEF-1 / IEF-3},
      ddc          = {620},
      cid          = {I:(DE-Juel1)VDB809 / I:(DE-Juel1)VDB811},
      pnm          = {Rationelle Energieumwandlung / SOFC - Solid Oxide Fuel Cell
                      (SOFC-20140602)},
      pid          = {G:(DE-Juel1)FUEK402 / G:(DE-Juel1)SOFC-20140602},
      shelfmark    = {Electrochemistry / Energy $\&$ Fuels},
      typ          = {PUB:(DE-HGF)16},
      UT           = {WOS:000277868600020},
      doi          = {10.1016/j.jpowsour.2010.03.030},
      url          = {https://juser.fz-juelich.de/record/9390},
}