% IMPORTANT: The following is UTF-8 encoded.  This means that in the presence
% of non-ASCII characters, it will not work with BibTeX 0.99 or older.
% Instead, you should use an up-to-date BibTeX implementation like “bibtex8” or
% “biber”.

@ARTICLE{Steudel:827140,
      author       = {Steudel, I. and Huber, A. and Kreter, A. and Linke, J. and
                      Sergienko, G. and Unterberg, B. and Wirtz, M.},
      title        = {{M}elt-layer formation on {PFM}s and the consequences for
                      the material performance},
      journal      = {Nuclear materials and energy},
      volume       = {9},
      issn         = {2352-1791},
      address      = {Amsterdam [u.a.]},
      publisher    = {Elsevier},
      reportid     = {FZJ-2017-01338},
      pages        = {153 - 156},
      year         = {2016},
      abstract     = {One of the numerous challenges of the demonstration power
                      plant DEMO is the selection of appropriate plasma facing
                      materials (PFMs) and this task is ultimately important to
                      the success for DEMO. Low-activation stainless steel (e.g.
                      EUROFER, P92), which is already intended as structural
                      material, could also become a possible plasma facing
                      material, e.g. for the first wall (FW). Therefore, the
                      ferritic martensitic steel P92 was investigated under DEMO
                      relevant loading conditions. An area of the sample surfaces
                      was firstly molten by transient events with varying power
                      densities (A = 245 MW/m2, B = 708 MW/m2) and afterwards
                      simultaneously and sequentially exposed to thermal and
                      particle loads. Surface modifications and pronounced
                      microstructure changes were investigated dependent on the
                      pre-exposure, loading sequence and power density. More
                      precisely, it turned out that there was no connection
                      between the loading sequence and the surface modifications
                      for the preloaded A-samples contrary to preloaded B-samples.
                      The preloaded B-samples exhibited surface roughening,
                      melting and the formation of holes dependent on the loading
                      sequence and power density.},
      cin          = {IEK-4 / IEK-2},
      ddc          = {333.7},
      cid          = {I:(DE-Juel1)IEK-4-20101013 / I:(DE-Juel1)IEK-2-20101013},
      pnm          = {113 - Methods and Concepts for Material Development
                      (POF3-113) / HITEC - Helmholtz Interdisciplinary Doctoral
                      Training in Energy and Climate Research (HITEC)
                      (HITEC-20170406)},
      pid          = {G:(DE-HGF)POF3-113 / G:(DE-Juel1)HITEC-20170406},
      typ          = {PUB:(DE-HGF)16},
      UT           = {WOS:000391191500026},
      doi          = {10.1016/j.nme.2016.08.002},
      url          = {https://juser.fz-juelich.de/record/827140},
}