| Hauptseite > Workflowsammlungen > Publikationsgebühren > Directly coated membrane electrode assemblies for proton exchange membrane water electrolysis |
| Typ | Amount | VAT | Currency | Share | Status | Cost centre |
| APC | 500.00 | 0.00 | EUR | 100.00 % | (Zahlung erfolgt) | ZB |
| Sum | 500.00 | 0.00 | EUR | |||
| Total | 500.00 |
| Journal Article | FZJ-2019-06525 |
; ; ; ; ; ; ;
2020
Elsevier Science
Amsterdam [u.a.]
This record in other databases:
Please use a persistent id in citations: http://hdl.handle.net/2128/23854 doi:10.1016/j.elecom.2019.106640
Abstract: We present a novel membrane electrode assembly (MEA) fabrication method for proton exchange membrane water electrolysis (PEMWE). Inspired by previous work on PEM fuel cells (PEMFCs), we fabricated PEMWE-MEAs via direct membrane deposition (DMD). DMD-MEAs were fabricated by spray coating the membrane directly onto the cathode electrode – in this case, a carbon cloth substrate with microporous layer coated with Pt/C. The complete DMD-MEAs consisted of the membrane-cathode compound assembled with an anode electrode, which is a porous titanium fiber substrate coated with IrO2. Polarization experiments of DMD-MEAs show promising results: In comparison to a reference catalyst coated membrane (CCM) and a porous transport electrode (PTE) type MEA using a freestanding Nafion 117 membrane, we found very good electrochemical performances for DMD-MEAs. DMD-MEAs show slightly higher activation losses than the reference CCM. However, DMD-MEAs seem to exhibit reduced ohmic and mass transport losses compared to those manufactured using the CCM approach. Compared to the PTE-type reference DMD shows improvements for all three loss mechanisms. Similar as for PEMFCs, DMD may allow for a simplified fabrication route and higher degree of design freedom in PEMWE-MEA manufacturing due to the simple layer by layer fabrication approach.
|
The record appears in these collections: |